Tapping Right Column Mount
A proposed by experienced builders on the murphy builder list, we tapped the holes into the fuselage bottom. AN3 screws will replace the rivets. In this way I can …
Mixer Arm Frame
This is the place, where the mixer arm will be installed to. I decided to put the green aluminum onto the side. Not required but seems good for the …
Mixer Arm Done
After some sanding, here is the final mixer arm, ready for installation.
Fabricating Mixer Arm
The mixer arm has to be fabricated out of a aluminum bar. This is definitely the point where you need a good band saw. Mine is not the best. …
Sanding Control Column
To minimize friction at the control column, I removed the black color. I think pure metal will have less friction in the lexan base than the black coating.
Enlarging Opening in Bearing Base
The delrin blocks in the bearing base were to tight. I had to sand them to allow a good fit of the control column. I used a tube of …